Using the Lantronix Device Installer software, a timer may change the IP address of a Lite Reader with serial number AB000251 or greater. Below are directions on how to change the IP Address after installing the Lantronix Device Installer (see attachment).
  1. Open Device Installer
  2. Connect Lite Reader to computer via Ethernet cable
  3. Turn on reader
  4. Search
    • NOTE: The software may not select your Ethernet connection automatically. If this occurs, select Tools > Options. Check the box beside the Ethernet network adapter in the list, and then click OK.
  5. Under Lantronix Devices, select Local Area Connection > Wireless >  WiPort b/g - firmware
  6. Double-click reader's IP address
  7. Select Assign IP
  8. Next
  9. Complete the following:
    1. IP address
    2. Subnet Mask
    3. Default gateway (Optional)
  10. Next
  11. Assign
  12. Finish