Unable to Interface in File Sharing Mode
- Go to Run > Interfaces > Photo Finish > Update Start Lists in Meet Manager
- Check the following
- Activate update of start lists is checked
- Note: If it is not checked MM will not create start list files
- Shared Location for Data shows near bottom of screen
- If location is correct, click OK (start list files will be created and put in shared location)
- If location is not correct, click Change Data Location and select correct location
- Note: If shared location is on another computer, map that location (Computer > Map Network Drive)
- Note: Meet Manager and Photo Finish software need to point to same shared location
- Check that start list files are in selected Data Location
- For FinishLynx, Eagle Eye & Flash Timing , 3 files created are lynx.evt, lynx.ppl and lynx.sch
- For Omega Star, start list files created are startlist.csv and concat.txt
- Note: If start list files are in correct location and Photo Finish System cannot find them, update location
Was this article helpful? YES NO
