A timer may save participant or competitor times on a Lite Reader using a USB flash drive. Lite Readers are shipped with a 4GB flash drive when purchased from Active. Below are directions for saving reads to a USB flash drive prior to race start.

Note: IPICO readers use beeps to notify timer of issues, please pay attention to beep counts

1. Open Lite Reader lid
2. Toggle Power Switch to On position
3. Insert USB flash drive to USB port
Note: Must hear two beeps after inserted for reads to save
Note: Up to 32GB USB flash drive may be used
Note: Larger flash drives take longer to initiate saves
4. Run race
5. Once Race is over > press Plunger down until 4 beeps are heard
Note: Reads are not saved to USB flash drive until Plunger pressed and 4 beeps heard
Note: Prior to pressed Plunger, reads are saved in a buffer that will be deleted if USB flash drive not ejected properly